![]() The lates TDA100 Version for me is 5.0100 (never used TDA100D. Please confirm the above RE: KX-TDA100D Version Upgrade Guide TheCoreWithin (Programmer) 29 Sep 15 09:26ġ> Its yust to safe the running confing to your DSYSEģ> DSYS is for TDA / correct (DBSYS is NCP)ħ> You sould get teh lastes Software from your distributor, an panasonic dealer, i could get it for you but then its NL version, backup the old folder for safty, i use the maintain console V 7.8.1.1 AT THIS STEP THERE IS REALLY NOTHING TO DO? AS THE CONFIGURATION IS AS THE OLD ONE WHICH I WOULD LIKE TO MAINTAINġ3> connect to the "new" version pbx / upload the config file ( file transfer PC -> PBX)ġ4> reset by command -> skip the save -> replace the DBsys for yoursġ6> if anny set SVM ous / transfer message back to card / set ins again OK, I JUST DONE THIS AWHILE AGO, IT DOES NOT ASK TO CONVERT. ANOTHER THING IS WHERE THE UPDATE FILES CAME FROM?ġ1> now the system is standaart 192.168.0.101 / pass 1234, login and yust put pass 1234 and skipp all, even IP settings, yust skipp all, ( if 1st time ask for language files update upload them en do the system initial again after the SD card finising blinking), then skipp all again.ġ2> open your DSYS whit your new maintenance console ( offline), it will ask you to convert, do it and save your new config file ( check the timers and everyting u whant to check ) OK, AT THE BOTTOM, I CAN SEE VERSION 008-000 | REGION 000-000, DID I JUST SEE THE VERSION IS ACTUALLY V8? A NEW PRIVATE FOLDER? SHOULD I DELETE THE OLD PRIVATE FOLDER? NOW, WHAT DO YOU MEAN BY LOCAL DISTRIBUTOR? THE NEW CONSOLDE I WILL BE USING 7.1.1.4 | GUI/API 5.0.1.13Ĩ> be4 putting in the SD switch the NORMAL / SYSTEM INITIAL to SYSTEM INITIALĩ> do the SD card in and pin the RESET buttonĪM I RESETING THE PABX CONFIGURATION? YES?ġ0> the green led will flash, while flashing toggle the switch back to NORMAL now he will update your PBX to V8.0101 RATHER THAN "DBSYS" I GOT DSYS, WHICH I ASSUME IT IS THE SAME.Ĥ> Transfer Message to PC ( The SVM / and or cardĥ> remove the SD Card and get the LIC files ( if anny )Ħ> save the whole old PRIVAT map and call it PRIVAT_OLD ( Backup all )ħ> set an new PRIVAT map on the SD Card from your local distributeur (and be sure to install the lates maintenance console) ![]() ![]() Ok, here is the steps you provided in the other link.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |